Table of Contents
Advertisement
11
TUNING THE CHASSIS
11.14
Handlebar position
11.15
Adjusting the handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
–
Turn the red adjusting screw
Info
Adjusting screw
The rebound damping is located in the right fork leg REB (red adjusting
screw). The compression damping is located in the left fork leg COMP (white
adjusting screw).
–
Turn back counterclockwise by the number of clicks corresponding to the fork type.
Guideline
L00175-10
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
On the upper triple clamp, there are two holes at a distance of
Hole distance
The holes on the handlebar supports are placed at a distance of
Hole distance
The handlebar supports can be mounted in four different positions.
101859-10
x
–
Remove the four screws
and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar holders in the required position. Mount and tighten the two
101860-10
screws
.
2
Guideline
Screw, handlebar holder
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
all the way clockwise.
1
is located at the upper end of the right fork leg.
1
15 mm (0.59 in)
A
3.5 mm (0.138 in)
B
. Take off the handlebar clamps. Take off the handlebar
1
. Remove the handlebar holders.
2
M10
15 clicks
13 clicks
11 clicks
to each other.
A
from the center.
B
40 Nm
Loctite
(29.5 lbf ft)
39
®
243™
Advertisement
Table of Contents
