Manual Lighting - Weber Q 300 Owner's Manual

MANUAL LIGHTING

Failure to open the lid while igniting the barbecue's burners, or
not waiting 5 minutes to allow the gas to clear if the barbecue
does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
1) Open the lid.
2) Make sure all burner control knobs are turned OFF. (Push each knob in and turn
clockwise to ensure they are in the off position.)
WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane cylinder valve.
If they are not in the OFF position, when you turn on the
LP cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP tank valve and burner control
knobs. Start over.
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning OFF the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. Failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
3) Turn the cylinder on by turning the cylinder valve counterclockwise.
4) Strike a match and put the flame into the matchlight hole under the igniter.
WARNING: Do not lean over open barbecue when lighting
the barbecue.
5) Select Outside burner, push control knob in and turn to START/HI.
6) Check that the burner is lit by looking down through the cooking grate. You should
see a flame.
WARNING: If the burner does not light, turn the burner
control knob to OFF and wait 5 minutes to let the gas clear
before you try again.
7) After the Outside burner is lit you can turn on the Inside burner. The Inside burner
is ignited from the Outside burner.
OPERATING INSTRUCTIONS
DANGER
DANGER
A
TO EXTINGUISH
Push down and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.
25
B C D