Tilting The Seat Assembly Forward - Invacare Pronto M91 User Manual

8. Remove prop rod from the clip located on the Formula PTO Plus frame and engage the prop rod end into the front seat post as shown in
FIGURE 15.
9. Gently allow weight of seat assembly to be supported by the prop rod.
Only leave the seat assembly in the up/open position while performing any necessary procedures. Always lower the seat

assembly to the down/closed position when not servicing the wheelchair and ensure it is in the locked position before using.

Tilting the Seat Assembly Forward

1. Using one hand, firmly grasp the front edge of the seat assembly and
lift until seat assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the front seat post and secure into
clip.
3. Using both hands, slowly tilt the seat assembly Forward into the
Down/Closed position.
WARNING
Ensure the two screws are fully engaged and the
Formula PTO Plus frame is securely locked in
place before use - otherwise injury or damage may
result.
4. Insert the two screws through the washers, the Formula PTO Plus
frame and the two front seat posts.
Part No 1143153
Formula PTO Plus Frame
Front Seat Post
Screw
Washer
FIGURE 15
65
5 WHEELCHAIR OPERATION
Mounting
Prop Rod
Tilting the Seat Assembly
Invacare® Pronto® M91™
Hole
Clip