Tilting The Seat Assembly Forward - Invacare Pronto M51 Base Owner's Operator And Maintenance Manual

SECTION 6—SEAT
9. Gently allow weight of seat assembly to be supported by the prop rod.
NOTE: Only leave the seat assembly in the Up/Open position while performing any necessary
procedures. Always lower the seat assembly to the Down/Closed position when not servicing the
wheelchair. Ensure the seat is locked in place before using.

Tilting the Seat Assembly Forward

1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat
assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the front seat post and secure into clip.
3. Using both hands, slowly tilt the seat assembly Forward into the Down/Closed
position.
Ensure the two screws are fully engaged and the seat assembly is securely locked in
place before use - otherwise injury or damage may result.
4. Using the two screws and locknuts, secure the seat assembly to the two front seat
posts.
Clip
Prop Rod
FIGURE 6.1 Tilting the Seat Assembly (Formula CG Only)
® ™
Pronto M51 Base with SureStep
WARNING
® 42
Seat Assembly
Screw
Locknut
Front Seat Post
Part No. 1148076