7 SETUP/MAINTENANCE
Removing/Installing the Elevating Seat Assembly
For this procedure, refer to FIGURE 4.
It is strongly recommended that two assistants lift the seat assembly when performing this procedure.
Removing
1.
Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 104.
2.
Remove the seat cushion.
3.
Remove the two socket screws securing the seat pan to the seat
frame.
4.
Remove the seat pan from the seat frame.
5.
Remove the four mounting bolts and locknuts securing the seat
assembly to the actuator post.
6.
Remove the seat assembly from the actuator post and set aside.
Installing
1.
Position the seat assembly onto the actuator post.
2.
Using four mounting bolts and locknuts, secure the seat assembly
to the actuator post. Securely tighten.
3.
Position the seat pan onto the seat frame as shown.
4.
Using the two socket screws, secure the seat pan to the seat frame.
5.
Install the seat cushion.
6.
Connect the joystick. Refer to Disconnecting/Connecting the
Joysticks on page 104
Invacare® TDX® SC, Invacare TDX Spree
Mounting Bolts
Seat
Assembly
Locknuts
FIGURE 4
Removing/Installing the Elevating Seat Assembly
94
Complete seat
assembly not shown.
Seat pan and socket
screws not shown.
Actuator
TDX SC with
Post
elevating seat shown.
TDX Spree seating
removes the same.
Part No 1149267