Batteries - Invacare TDX SC User Manual

7.4

Batteries

WARNING
Invacare strongly recommends that battery installation and battery replacement always be done by a qualified technician.
The use of rubber gloves is recommended when working with batteries.
After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely -
otherwise injury or damage may result.
U1 batteries weigh 24 pounds each. Use proper lifting techniques (lift with your legs) to avoid injury.
ALWAYS use a battery handle/lifting strap when lifting a battery. It is the most convenient method and assures that the
battery acid will not spill.
DO NOT tip the batteries. Keep the batteries in an upright position.
NEVER allow any of your tools and/or battery cable(s) to contact BOTH battery post(s) at the same time. An electrical
short may occur and serious personal injury or damage may occur.
When tightening the clamps, always use a box wrench. Pliers will "round off" the nuts. NEVER wiggle the battery
terminal(s)/post(s) when tightening. The battery may become damaged.
The POSITIVE (+) RED battery cable MUST connect to the POSITIVE (+) battery terminal(s)/post(s), otherwise serious
damage will occur to the electrical system.
Install protective caps on POSITIVE (+) and NEGATIVE (-) battery terminals.
DO NOT remove fuse or mounting hardware from POSITIVE (+) red battery cable mounting screw.
Unless otherwise indicated, make sure power to the wheelchair is OFF before performing these procedures.
If there is battery acid in the bottom of the battery box or on the sides of the battery(ies), apply baking soda to these areas

to neutralize the battery acid. Before reinstalling the existing or new battery(ies), clean the baking soda from the battery
tray or battery(ies) being sure to avoid contact with skin and eyes. Determine source of contamination. NEVER install/
reinstall a battery with a cracked or otherwise damaged case.
Part No 1149267
83
Invacare® TDX® SC, Invacare TDX Spree
7 SETUP/MAINTENANCE