Index
Category
4.
LAG
5.
LAG
6.
LAG
7.
LAG
8.
VLAN
9.
Spanning Tree
10.
IGMP Snooping
11.
ACL
12.
ACL
13.
ACL
Description
The remote LACP admin-key #1 cannot be estab-
lished with some third party vendors.
Traffic running over LAG may not be evenly dis-
tributed when testing small number of SMACs.
A port-channel stops forwarding traffic after dis-
abling some Ethernet ports in the same port-chan-
nel group.
When converting static LAG to dynamic LAG
(LACP), some of the ports remain in 'DOWN'
state.
It might take approximately 20 seconds to create/
delete 1000 VLANs, or to change the switchport
mode of an interface.
Non-standard behavior may occur on third party
switch STP functionality when the port moves
from Root to Alternate state. The standard Pro-
posal-Agreement sent by MLNX-OS is unan-
swered which may result in traffic loss of up to 30
seconds.
Setting the "ip igmp snooping unregistered multi-
cast" option to "forward-to-mrouter-ports" option
reduces the amount of supported VLANs to 250.
A mask of IPv4 ACL rule can contain either 255
or 0 in any of the 4 bytes assembling it.
ACL is not supported on split interfaces.
Removing configured ACL on split interfaces
requires reset factory.
Possible Workaround
Use a different admin-key
number.
Disable and enable the
LAG.
Disable and enable the
LAG.
Mellanox Technologies
8