3Com Server User Manual page 29

3com token ring-in-fast ethernet server network interface card user guide
Table of Contents

Advertisement

Table 4-4 Troubleshooting Tips (continued)
Symptom
The NIC fails
diagnostic tests.
Tip
If the NIC fails the Group 3 diagnostic test, be sure that
the test is set up correctly, that the NIC is connected to
an inactive, properly cabled network, and that an echo
server is set up on the network.
Replace the failed NIC with a working NIC.
Run the diagnostic tests again, using the same option
settings as those used on the failed NIC. If the working
NIC passes all tests, the original NIC is probably defective.
For information on product repair, see
Install the NIC in another functioning PC.
Run the tests again. The first PC you used for testing may
be defective if the NIC passes the tests in this PC.
Remove all other NICs from the PC and run the tests
again.
If the tests pass, the other NICs may be causing
contention. Check the configuration settings. Change
the settings if they conflict with another device. See
Chapter
5.
Further Testing
Appendix
B.
4-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

3c395

Table of Contents