Changing The Test Setup; Getting Help If A Test Fails - 3Com Server User Manual

Changing the Test Setup

You may want to change certain aspects of a test; for
example, the number of times the test repeats or whether
the test halts when it encounters an error. If you need to
change the test setup, follow these steps:
1 From the Test menu, select Test Setup. Or, in the
Run Tests dialog box, select Test Setup.
2 Select any Test Setup dialog box field.
3 In the Group Select box, select a test group.
4 Change the test setup.
For example, if you select the Group 1 tests, you can make
the following changes to the setup:
5 Select OK.
6 From the Test menu, select Run Tests. Select Start to
run the tests.

Getting Help If a Test Fails

If a test fails, the NIC may not be defective. The problem may
be incorrect option settings, option settings that conflict
with the settings of other boards, or improper installation.
If a DOS diagnostic test fails, you can get additional
information as follows:
In the Group X Tests box, select a test. Press the
spacebar to enable or disable an individual test.
In the Repetitions box, specify the number of times you
want to run the tests, or select the Continuous option.
In the Errors box, press the spacebar to select or
deselect the Halt on Error parameter.
From the Run Tests dialog box, select the test that failed,
and press Enter.
Select Zoom and press Enter.
DOS Diagnostic Tests 4-5