Ipv6 Hop-Limit - HP 6125XLG Command Reference Manual

remains. After you delete the manually assigned address, the automatically generated link-local address
takes effect. For automatic generation of an IPv6 link-local address, see the ipv6 address auto link-local
command.
Examples
# Configure a link-local address for VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address fe80::1 link-local
Related commands
ipv6 address auto link-local

ipv6 hop-limit

Use ipv6 hop-limit to set the Hop Limit field in the IPv6 header.
Use undo ipv6 hop-limit to restore the default.
Syntax
ipv6 hop-limit value
undo ipv6 hop-limit
Default
The hop limit is 64.
Views
System view
Predefined user roles
network-admin
Parameters
Value: Specifies the number of hops, in the range of 1 to 255.
Usage guidelines
The hop limit determines the number of hops necessary for an IPv6 packet to reach its destination.
If the device advertises the hop limit in RA messages (set with the undo ipv6 nd hop-limit unspecified
command), all RA message receivers uses the value set with the ipv6 hop-limit command to fill in the Hop
Limit field.
Examples
# Set the maximum number of hops to 100.
<Sysname> system-view
[Sysname] ipv6 hop-limit 100
Related commands
ipv6 nd hop-limit unspecified
178