GE IM4A Owner's Manual And Installation Instructions page 31

4
INSTALL THE MOUNTING BLOCK
• Inside the freezer, remove the two small white plug
buttons from the side wall.
• Using the Phillips head screws
that are with the mounting
block, attach the mounting
block to the refrigerator by
driving the screws through the outer holes on
the block and into the holes that the plug buttons
were in.
• Install two self-tapping Phillips head screws (11)
from the kit in the inner holes on the mounting
block. On some models, the screws may already be
in place on the mounting block. The screw heads
should extend about 1/2" (13 mm) from the
mounting block.
5
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
6 PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched. Press
the plug firmly into the socket. Lock the plug in
place by clipping the restraints onto each side of the
plug. Make sure the restraints click into place. Make
sure the power cord is still in the hook on the back
of the icemaker.
Hook
Installation Instructions
15
31
MOUNT THE ICEMAKER
7
• Lift the icemaker so the fill tube (13) fits in the
fill cup opening (E). Hang the icemaker on the
two mounting screws (11) on the mounting block.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (13) extends into the fill cup
opening on the back of the icemaker. (Check
the rear of the refrigerator to make sure the fill
tube has not been pushed out of the back of
the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
• The icemaker power switch is set to O (off).
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
11
8 INSTALL THE ICE BUCKET
Place the lower freezer
basket back into the
freezer drawer.
The upper freezer
basket is actually
2 baskets hooked together.
Remove basket on the left
by unhooking it.
Place the remaining
upper basket in the freezer
drawer on the right side. Place the ice bucket in
the left side of the lower basket.
9
ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
10
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
13
E