GE IM4A Owner's Manual And Installation Instructions page 21

CONNECT WATER TUBE
3
TO INLET
Squeeze the ends of the hose clamp (16) from the
•
kit with pliers and slide the clamp over the inlet,
located in the top right corner of the refrigerator.
• While still squeezing the clamp, insert the free end
of the water tube (3) into the inlet as far as it will go.
• Then slide the clamp downward to capture the
water tube in place.
• Using one of the adhesive-backed fasteners (4),
secure the water tube to the back of the refrigerator
about 1/2" below the inlet.
Inlet
Inlet Cover
16
4
INSTALL WATER LINE CLAMP
4
Attach the water line clamp (strain relief) (6)
•
from the kit to the refrigerator. With the clamp
directly in line with the water valve, drive the
screw (5) from the kit through the clamp (6)
at the indent into the back of the cabinet.
The metal clamp is for the house water line (see
•
Water Line Installation Instructions). It is not to
be used for the water tube from the water valve
up to the inlet.
Installation Instructions
3
5
6
ROUTE AND ATTACH
5
THE WATER TUBE
Fasten the plastic water tube to the back of the
•
refrigerator with adhesive-backed fasteners (4),
spacing the fasteners as shown to take up slack
in the tube.
WATER VALVE INSTALLED
6
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
21
Adhesive-backed fasteners
for water tube