Tools You Will Need; Remove The Cover - GE IM4A Owner's Manual And Installation Instructions

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator ---
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.

TOOLS YOU WILL NEED

Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers

REMOVE THE COVER

1
At the bottom rear of the refrigerator, remove the
screw(s) holding the access cover.
Bend the cover back for access to the compartment.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
Installation Instructions
L
Unplug the
Sharp knife
Pliers
or S
M N P Q R
2 ATTACH THE WATER VALVE
• Locate the female connector plug (C), which is
attached to the cabinet by a metal or plastic clip.
Remove the clip by removing the screw.
• Plug the female connector (C) onto the male
terminals on the water valve (3). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet by driving
the hex-head screw (10) from the kit into the
hole in the cabinet leg.
12
Metal or plastic clip
C
C
3
10