Selecting The Digital Attenuator; Adjusting Display Contrast - Pioneer FH-P4000 Operation Manual

Initial Settings
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 38).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
:FUL
(subwoofer) and that status will be displayed.

Selecting the digital attenuator

When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in distor-
tion. You can switch the digital attenuator to low
to reduce distortion.
• Sound quality is better at the high setting so
this setting is usually used.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
high or low with 2/3.
2 Select
DIG.ATT
Pressing 2/3 will switch
high and low and that status will be displayed
(e.g., ).
DIG.ATT: H
.
REAR SP
REAR SP
REAR SP
REAR SP :S/W
.
DIG.ATT
DIG.ATT
between
DIG.ATT

Adjusting display contrast

Display contrast adjustment lets you adjust the
display for easier viewing when lighting condi-
tions change.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Press 2 or 3 to adjust the contrast.
Each press of 2 or 3 increases or decreases
the contrast.
• – is displayed as the contrast is
+7 –7
increased or decreased.
Section
10
.
CONTRAST
CONTRAST
41
En