Installing An Attenuator - Dish Network digital remote control User Manual

4. Press the Pound (#) button. If the address you
entered is valid for the remote control, the SAT
mode button backlight flashes three times.
5. Press the Record button.
The Remote Address on the Important
System Information menu should match
the one that you entered.
6. To check the address, press and hold the SAT
mode button for three seconds. Then, press the
Pound (#) button twice. The SAT mode button
backlight flashes the same number of times
as the address.
7. Press the Select button.
I
NSTALLING AN
Unwanted UHF signals may block signals from the remote control
to the receiver. To prevent such blockage, you can install a 10 dB
attenuator. This will help keep out other UHF signals, but also reduce
the distance at which you can use the remote control.
1. Remove the UHF antenna
from the UHF Remote
Antenna connection on the
receiver back panel.
2. Attach a 10 dB attenuator to the
UHF Remote Antenna
connection.
3. Attach the UHF antenna to the
attenuator.
104333
A
TTENUATOR

Installing an Attenuator

17