Using The Remote Control Buttons; Sat (Satellite Receiver) Mode - Dish Network digital remote control User Manual

SAT (Satellite Receiver) Mode

U
SING THE
SAT (S
ATELLITE
SAT M
The remote control already is set up to control the satellite receiver.
But, you must press the SAT mode button to set the remote to SAT
mode. The SAT mode button's back light turns ON to show that the
remote is set to SAT mode. Make sure to keep the remote in SAT
mode to use the buttons as described in this section.
AUX M
Set up the remote to control the television and do not setup the remote
in AUX mode. If you do this, then with the remote in SAT mode you
can press the AUX mode button to turn the television ON or OFF.
This allows you to turn the TV on or off without leaving SAT mode.
If you connect the receiver using only its back panel RF or VHF
connections, use this button to switch the receiver between the satellite
signal (routed into the receiver's Satellite In input) and another video
signal such as cable or broadcast TV antenna input (routed into the
receiver's TV Antenna Cable In input).
M
Press this button to open the Main Menu.
4
R
EMOTE
R
ECEIVER
Some of the features described below may not
apply to your satellite receiver. See the receiver
User Guide for details about the receiver's features.
If a remote control button is not described in this
section, it does not work in SAT mode.
B
ODE
B
ODE
TV/V B
IDEO
B
ENU UTTON
C
ONTROL
) M
ODE
UTTON
UTTON
UTTON
B
UTTONS
104333