Hp Nc522Sfp Dual Port 10Gbe Server Adapter Option; Redundant Hot-Plug Power Supply Option - HP DL360 User Manual

HP NC522SFP Dual Port 10GbE Server Adapter
option
To install the component:
Power down the server (on page 20).
1.
Extend the server from the rack (on page 20).
2.
Remove the access panel (on page 22).
3.
Remove the PCI riser board assembly (on page 24).
4.
Remove expansion slot cover 1 from the PCI riser board assembly.
5.
Install the adapter in slot 1 on the PCI riser board assembly.
6.
Install the PCI riser board assembly (on page 25).
7.
Install the access panel (on page 22).
8.
Slide the server into the rack.
9.
Power up the server (on page 20).
10.

Redundant hot-plug power supply option

CAUTION:
capacity. Verify that all power supplies have the same part number and label color. The system
becomes unstable and may shut down when it detects mismatched power supplies.
Label color
Blue
Orange
Green
All power supplies installed in the server must have the same output power
Output
460W
750W
1,200W
Hardware options installation 64