QMS Magicolor WX User Manual page 198

This message . . .
PAPER OUT UPPER,
OR MANUAL FEED TRAY
PLEASE CLOSE
MANUAL FEED TRAY
PLEASE OPEN
MANUAL FEED TRAY
PLEASE SET MEDIA
FROM DRIVER
PLEASE WAIT
BOOTING
PLEASE WAIT
ERASING FLASH
PLEASE WAIT
WARMING UP
PLEASE WAIT
WRITING FLASH
PRINT JOB
ACTIVE
PRINTING
PRINTING
NEED MORE MEMORY
PRINTING
PAPER MISMATCH
REPLACE BELT
means . . .
The manual feed tray is empty; reload the tray.
(See chapter 2, "Printing," for information on
refilling cassettes.)
The manual feed tray is open when a file is
being sent to print from another cassette.
Close the manual feed tray.
The manual feed tray has been selected as the
input media source, but it is not open.
The Media key was pressed. This key is not
used. (It is available to allow you to upgrade
your printer to a fully networkable, departmen-
tal color printer, the QMS CX Print System.
Contact your QMS vendor for specifications
and purchase information.)
The printer is starting up.
The old system software is being erased from
flash memory.
The printer is getting ready to go on line.
The new system software is being written to
flash memory.
A print job is being received by the printer, but
it has not yet begun to print.
The printer is on line and printing.
The printer is on line and printing, but it needs
more memory to print the file. It will print as
much of the page as it can currently fit in
memory.
The media size in the default media cassette is
different from that chosen in the printer driver.
The job will print on the installed media size.
The OPC belt cartridge needs to be replaced.
(See chapter 5, "Maintenance," for details.)