Replacing The Battery; Replacing The Fuse - Craftsman 82345 Owner's Manual

REPLACING THE BATTERY

WARNING: To avoid electric shock, disconnect the test leads
from any source of voltage before removing the battery cover.
1. When the battery become exhausted or drop below the
operating voltage, "
the LCD display. The battery should be replaced.
2. Follow instructions for installing battery. See the Battery
Installation section of this manual.
3. Dispose of the old batteries properly.
WARNING: To avoid electric shock, do not operate your
meter until the battery cover is in place and fastened securely.

REPLACING THE FUSE

WARNING: To avoid electric shock, disconnect the test leads
from any source of voltage before removing the fuse cover.
1. Disconnect the test leads from the meter and any item under
test.
2. Remove the protective rubber holster.
3. Remove the two screws securing the rear cover using a
Phillips head screwdriver.
4. Remove the old fuse from its holder by gently pulling it out.
5. Install the new fuse into the holder.
6. Always use a fuse of the proper size and value
(250mA/250V) fast blow.
7. Replace the rear cover and secure with the screws.
WARNING: To avoid electric shock, do not operate your
meter until the fuse cover is in place and fastened securely.
UL LISTED
The UL mark does not indicate that this product has been
evaluated for the accuracy of its readings.
" will appear in the lower left corner of
18