Brother P-Touch 3600 User Manual page 86

ERROR MESSAGE LIST
ERROR MESSAGE
CHARGE BATTERIES!
(PT-9600 only)
CLOSE CASSETTE
COVER!
CUTTER ERROR!
EEPROM ERROR!
FEED ERROR!
INPUT WHOLE CODE!
78
CAUSE
● This message appears when the
rechargeable Ni-MH battery has
reached a low voltage.
● This message appears if the tape
compartment cover is open.
● This message appears if the cut-
ter did not operate correctly.
● This message appears if a
checksum error occurred when
the P-touch was turned on or if
the keyword was damaged and
failed to initialize.
● This message appears if the AV
label sensor cannot detect the
labels.
● This message appears if the set
number of digits is not entered
in the barcode data.
SOLUTION
● Recharge the battery or
use the AC adaptor.
● Close the compartment
cover.
● Turn off the P-touch, and
then turn the P-touch on
again.
● If the problem cannot be
corrected, contact your
service representative.
● Contact your service rep-
resentative.
● Replace the AV label cas-
sette with one that is not
empty.
● If this error message
appears even after a new
AV label cassette is
installed, the sensor may
be damaged. Contact your
service representative.
● Input the correct number
of digits or change the
number of digits set in the
barcode parameters.