Brother P-Touch 3600 User Manual page 57

NOTE
☞
Since the text sizes that can be printed depends
on the width of the tape, the following table
shows the maximum text size that can be used
with each tape width.
The following text sizes do not apply to text
with a Text Rotation setting applied.
For TZ tapes:
Tape Width
1/4" (6 mm)
3/8" (9 mm)
1/2" (12 mm)
3/4" (18 mm)
1" (24 mm)
1 1/2" (36 mm)
For AV labels:
Label Sizes
AV2067 Address labels:
3/4" × 2 5/8" (20 mm × 67 mm)
AV1957 Return address labels:
3/4" × 2 1/4" (19 mm × 57 mm)
AV1789 File folder labels:
5/8" × 3 1/2" (17 mm × 89 mm)
☞
With the AUTO setting selected and the text in
a block consisting of just one line of only upper-
case letters (and no accented letters) and written
horizontally/vertically without the BERMUDA
font, the text is printed slightly larger than the
maximum possible for the tape width.
☞
If the 4 point or 5 point text size setting is
selected, the text will be printed with the BRUS-
SELS font setting, regardless of the font setting
that is selected.
Maximum Text Size
(in points)
12
20
28
40
64
76
Maximum Text Size
(in points)
48
36
36
To change the setting for the Size function:
1 Hold down d and press 1, 2 or 3.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until SIZE is displayed. The
setting for the text at the cursor's current
position is shown on the left side of the dis-
play and a sample can be seen on the right
side.
1 2 3 4 5 6 7 8 9
R
R
G
02/13
R
H N
R
SIZE
L M
R
I
AUTO
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed.
NOTE
☞
If "*****" appears as a setting, the Size function
has already been applied to either a line in the
current text block (if the Block Format or the
Global Format function is being set) or a block
in the current text (if the Global Format function
is being set). Changing the setting will cancel
the setting that was previously applied.
☞
To return the function to its default setting
(AUTO), press the space bar.
☞
To return to the text without changing the for-
e
matting, press
1 2 3
press , or
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
Ch. 3 Functions
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and
).
49