Kenmore 650-30643-0 Owner's Manual page 9

Installing Side Burner
1. Insert valve assembly through side panel right
(Fig. 5-a). Remove 4(four) screws & washers from
the "U" brackets on the side burner. (Fig. 5-b).
Insert valve stem assembly into burner tube (FIG
5-c).
2. Secure side valve to side control panel by using
philips head screws through the round cover plate
(know bezel). (Fig.6)
3. Replace "U" brackets with four screw(DO NOT
TIGHTEN, MAKE SURE HOSE IS NOT BENT).
(Fig.7). Then align & tighten knob seat & valve
stem with 2 screws & washers
4. Tighten all four screws on the "U" bracket on the
burner, then connect ignitor wire to ignitor. (Fig.8)
5. Secure knob to head of side valve with the
provided Allen Wrench. (Fig.9)
Installing S Hook
Align 4 S hooks into 4 holes in condiment holder,
and close (Fig.10)
Installing Side Handle
Secure side handle to left side shelf by using 5/32"
x 10mm Philips head screws. (Fig.11)
Figure 5-a
Figure 5-b
Figure 5-c
Figure 6
Ignition wire
3 0 0 4 0 0 5 0 0
2 0 0 6 0 0
1 0 0
8 0 0 7 0 0
3 0 0 4 0 0 5 0 0
2 0 0 6 0 0
1 0 0 7 0 0
8 0 0
P8
Figure 7
Figure 8
Figure 9 Figure 9
Figure10
Figure 11