Kenmore 650-30643-0 Owner's Manual page 10

Installing Condiment Rack
Attach condiment rack to inside door panel. (Fig.12)
Installing Cooking Components
Important: Before cooking on your grill the first time,
wash cooking grids and cooking rack with warm ,
soapy water. Rinse and dry thoroughly. Season with
cooking oil regularly. After cooking is completed, turn
grill for HIGH setting 3 to 5 minutes to burn off
excess grease or food residue.
1. Evenly space cooking grids on the ledge above
flame tamers. (Fig.13)
2. Place warming rack into the holes of the upper left
and upper right of grill bowl side panels. (Fig.13)
500
400 600
300 70 0
200 800
100
Ignitor Battery Installation
1. Unscrew the ignitor cap located on control panel
and remove the contact and spring from the ignitor
slot.
2. Place the manufacturer supplied AA battery into
the ignitor slot. Be sure to place the positive pole
facing toward you. (Fig. 14)
3. Place the spring over the AA battery, then place
the contact on top of the spring. Screw the ignitor
cap back onto control panel.
Figure 12
Installing Gas hose Retention Kit
1a. Insert "threaded end" mounting bolt through top
middle vent on the bottom right panel. (Fig 15-a)
1b. Tighten nut with washer from the out side of panel
with the provided wrench (Fig 15-b)
2a. Put regulator hose through ring clamp (Fig 15-c)
2b. Use wing bolt to fasten regulator hose to ring clamp
securely. (Fig 15-d)
Figure 13
Assembly Tips
3 00 400 500
600
2 00
100
800 7 00
Figure 15-a
Figure 15-c
P9
Figure 14
Figure 15-b
Figure 15-d