Power-Up - GE Interlogix Digital Video Multiplexer Recorder User Manual

RJ-45 Pin Configuration For Ethernet Port
Pin Use
1 TX+
2 TX-
3 RX+
4 Not Connected
RS232 Port 1
For a Modem connection or remote control of unit. See section 3.16 for information about configuring
the modem settings in the menu system. See section 9 for RS232 Remote Control Protocols.
DB-9 Pin Configuration For Port 1
Pin Use
1 DCD
2 RX
3 TX
RS232 Port 2 (StoreSafe Advanced Models Only)
For Event Generation and ASCII Text Insertion.
RJ-45 Pin Configuration For RS232 Port 2
Pin Use
1 Ground
2 Reserved
3 Not Connected
4 RXD

1.8 Power-Up

It is important that the power-up procedures be followed carefully. The unit uses its auto-detect
feature to detect camera signals during power-up, and configure itself automatically.
Power-up procedure
Once the system installation is complete, apply
power in the following order:
1. Energize the monitors and all of the cameras.
2. Energize StoreSafe.
Once power is applied to the unit, it will begin its power-up procedure. The unit will begin by displaying
the software version on Monitor-A, and then the unit will be ready for operation.
0150-0229D
Pin
5 Not Connected
6
7 Not Connected
8 Not Connected
Pin Use
4 DTR
5 Ground
6 Not Connected
Pin
5
6 Not Connected
7
8
13
Use
RX-
Pin Use
7 RTS
8 CTS
9 Not Connected
Use
TXD
Ground
Reserved
Power Supply Input
Voltage: 12 Volt DC
Power: 60 Watt (5 Amp)
Connector: 2.1mm barrel, center positive
Kalatel DVMRe StoreSafe
1 2 3 4 5 6 7 8
RJ-45 socket on back
panel.
1
6
DB-9 on back panel.
1 2 3 4 5 6 7 8
RJ-45 socket on
back panel.
5
9