Dimensions And Clearances; Single Surface Element Control Pad 10; Dual Surface Element Control Pad 10; Tri-Ring Surface Element Control Pad 10 - GE Profile PP945 Technical Service Manual

Dimensions and Clearances

The following MINIMUM clearance dimensions must
be maintained.
13" MAX. Depth of uprotected
overhead cabinets
30" MIN.
Clearance from
countertop to
unprotected
overhead
surface
2" MIN. Clearance
from cutout to
side wall on the
left of the unit
If a 30-inch clearance between the cooking
surface and overhead combustible materials or
metal cabinets cannot be maintained, a minimum
clearance of 24 inches is required and the
underside of the cabinets above the cooktop must
be protected with not less than ¼-in. insulating
millboard covered with sheet metal not less than
0.0122 inches thick.
Overall Cooktop Dimensions - 36-in. Models
36"
(36-1/8" SS)
Cooktop
33-3/4"
18-7/8"
Overall Cooktop Dimensions - 30-in. Models
29-3/4"
(29-7/8" SS)
Cooktop
33-3/4"
18-7/8"
2" MIN.
Clearance from
cutout to side
wall on the right
of the unit
15" MIN. Height
from countertop
to nearest
cabinet on either
side of unit
20-7/8" (21" SS)
Depth on Monogram ZEU36K
is 21-1/4" @ center.
3-1/4" Front
4-5/8" Rear
at the conduit
location
6-1/4" Rear
on Model PP975
& PP980
21-3/8" (21-1/2" SS)
3-1/4" Front
4-5/8" Rear
at the conduit
location
6-1/4" Rear
on Model PP945
& PP950
There must be 5 inches minimum vertical clearance
between the cooktop bottom and any combustible
surfaces.
Vertical Clearance
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand heat up
to 200°F (93°C) generated by the cooktop.
W all covering,
cabinets and
countertop must
withstand heat
up to 200°F ( 93° C ).
Note: The junction box must be located where
it will allow considerable slack in the conduit for
serviceability.
Install junction box so
that it can be reached
through the front of
– 7 –
5" Min.
16"
Min.
the cabinet.