Dimensions And Clearances - GE JGP3030 Installation Instructions Manual

DIMENSIONS AND
CLEARANCES
Provide adequate clearances between the
cooktop and adjacent combustible surfaces.
These dimensions must be met for safe use of
your cooktop.
Allow 30" (76.2 cm) minimum clearance
between burners and bottom of unprotected
wood or metal cabinet, or allow a 24" (61
cm) minimum when bottom of wood or metal
cabinet is protected by no less than 1/4" (6.4
mm) thick flame-retardant millboard covered
MAINTAIN THE FOLLOWING MINIMUM CLEARANCE
DIMENSIONS
of unprotected
overhead cabinets
from countertop
to unprotected
overhead surface
C - MIN. clearance
from cutout to rear wall
L - MIN. clearance from
cooktop to left side wall
2-1/2" MIN from cutout
to front of countertop
ALL HORIZONTAL
JGP3030, JGP3530, JGP3036
CLEARANCES MUST
JGP5030, PGP7030, PGP9030,
BE MAINTAINED FOR A
CGP9530
MINIMUM OF 18" ABOVE
JGP5036, PGP7036, PGP9036,
THE COOKING SURFACE.
CGP9536
NOTE: Allow 7/16" minimum vertical clearance from the cooktop
bottom (or 3-11/16" minimum depth from the countertop) to any
combustible surfaces, such as a cabinet drawer.
For island installation, maintain 2-1/2 in. minimum from cutout to front
and back edge of countertop. Maintain 3 in. minimum from cutout to
side edges of countertop.
with no less than No. 28 MSG sheet metal
(.015" [.38 mm] thick), .015" (.38 mm) thick
stainless steel, .025" (0.64 mm) aluminum or
.020" (0.5 mm) copper.
Installation of a listed microwave oven or
cooking appliance over the cooktop shall
conform to the installation instructions packed
with that appliance.
Built-in oven installation, shall conform to the
installation instruction packed with the built-in
oven.
R - MIN. clearance
from cutout to right
3 3/4 MIN.
side wall
from countertop to
nearest cabinet on
either side of unit
30" or 36"
cabinet base
or wider
C L R
2-1/4" 6" 6"
2-7/8" 12" 12"
3-3/8" 12" 12"
DRAWER
DRAWER
OVERALL COOKTOP DIMENSIONS
30" Models
Cooktop
CUTOUT DIMENSIONS OF COUNTERTOP
To ensure accuracy, it is best to make a template when cutting the opening in the counter.
30" Models
19-5/8" width cut
28-1/2"
length
of cut
RECOMMENDED GAS
SUPPLY LOCATION FROM
BACKWALL
FOR AMERICANS WITH
DISABILITIES ACT (ADA)
FORWARD APPROACH
INSTALLATION ONLY
NOTE: The enclosure must be made of wood
material. Also, an access panel is required for
the electrical outlet, pressure regulator, shut-off
valve, hold-down brackets, and service.
CONVERTING TO PROPANE GAS (OR CONVERTING BACK
TO NATURAL GAS FROM PROPANE)
This cooktop leaves the factory set for use with natural gas. If you want to convert to
propane gas, the conversion must be performed by a qualified propane gas installer.
The conversion orifices and instructions can be found attached to the regulator.
Keep these instructions and all orifices in case you want to convert back to natural gas.
36" Models
Cooktop
36" Models
19-1/8" width cut
33-7/8"
length
of cut
1" Min. From Backwall
Recommended
gas supply
location
From
Cutout
Center
Line
5"
Allow 5" minimum depth
between the countertop
and an enclosure.