Removing And Reinstalling The Front Bezel - Lenovo 10B0 Maintenance Manual

Removing and reinstalling the front bezel

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 90.
3. Remove the front bezel by releasing the three plastic tabs on the left side and pivoting the front bezel
outward.
Figure 16. Removing the front bezel
4. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis. Then, pivot the front bezel inwards until it snaps into position
on the left side.
.
Chapter 9 Replacing FRUs (machine types: 10B0, 10B1, 10B2, and 10B3)
91