Replacing The Solid-State Drive - Lenovo 10B0 Maintenance Manual

8. Position the new hard disk drive into the hard disk drive bay and align the screw holes in the new hard
disk drive with the corresponding holes in the drive bay. Then, install the four screws to secure the
new hard disk drive in place.
Figure 84. Installing the hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 186.

Replacing the solid-state drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the solid-state drive.
The solid-state drive is only available in some models. It might be installed in the hard disk drive bay or
on the bottom of the optical drive bay.
• To replace the solid-state drive in the hard disk drive bay, see "Replacing the solid-state drive in the hard
disk drive bay" on page 147.
• To replace the solid-state drive on the bottom of the optical drive bay, see "Replacing the solid-state drive
on the bottom of the optical drive bay" on page 149.
Replacing the solid-state drive in the hard disk drive bay
To replace the storage converter with the solid-state drive installed in it, you might follow the steps of
replacing the hard disk drive. See "Replacing the hard disk drive" on page 145.
To replace the solid-state drive in the storage converter, do the following:
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
147