Installing Or Removing The Rear Wi-Fi Antenna - Lenovo 10B0 Maintenance Manual

Machine types: 10b0, 10b1, 10b2, 10b3, 10b4, 10b5, 10b6, 10b7, 10ax, and 10ay
Hide thumbs Also See for 10B0:
Table of Contents

Advertisement

5. Release the front Wi-Fi antenna cable from the hooks on the hard disk drive bracket. Then, unstick the
front Wi-Fi antenna from the hard disk drive bracket.
Figure 190. Removing the front Wi-Fi antenna cable
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 239.

Installing or removing the rear Wi-Fi antenna

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to install or remove the rear Wi-Fi antenna.
Note: The rear Wi-Fi antenna is only available on some models.
To install the rear Wi-Fi antenna, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Install the rear Wi-Fi antenna to the rear Wi-Fi antenna cable connector attached on the rear of the
computer.
.
Chapter 11
Replacing FRUs (machine types: 10AX and 10AY)
223

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents