Lenovo 10B0 Maintenance Manual page 187

5. Install the rear Wi-Fi antenna to the rear Wi-Fi antenna cable connector. Then, adjust the angle of the
rear Wi-Fi antenna to prevent accidental breakage of the antenna.
Figure 131. Installing the rear WiFi antenna
6. Connect the rear Wi-Fi antenna cable to the Wi-Fi card module. See "Replacing the Wi-Fi units" on
page 174.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 186.
Removing the rear Wi-Fi antenna
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
To remove the rear Wi-Fi antenna, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 136.
3. Straighten the rear Wi-Fi antenna so that it can be more easily twisted.
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
181