Lenovo 10B0 Maintenance Manual page 163

7. Take the new slim card reader out of the static-protective package by its sides.
8. Align the new slim card reader in the slim card reader bracket and slide the slim card reader into the rail
as shown until it stops. Then, install the two screws to secure the new slim card reader to the bracket.
Figure 100. Installing the new slim card reader into the bracket
9. Route the cable of the new slim card reader through the corresponding hole for the slim card reader
bracket in the front of the chassis.
10. Install the slim card reader bracket into the chassis so that the hole in the bracket is aligned with the
corresponding hole in the chassis. Then, Install the screw to secure the slim card reader bracket to
the chassis.
Figure 101. Installing the slim card reader bracket
11. Connect the cable of the new slim card reader to the system board. See "Locating parts on the
system board" on page 80.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
.
Chapter 10 Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
157