Installing Or Removing The Hard Disk Drive Assembly - Lenovo 10B0 Maintenance Manual

5. Slide the computer cover toward the front of the computer a small amount. Then, lift the computer
cover to remove it from the computer.
Figure 172. Removing the computer cover

Installing or removing the hard disk drive assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to install or remove the hard disk drive assembly.
To remove the hard disk drive assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 211.
3. Locate the hard disk drive assembly in the computer. See "Locating major FRUs and CRUs" on page 85.
4. Disconnect the signal cable and the power cable from the hard disk drive.
.
Chapter 11 Replacing FRUs (machine types: 10AX and 10AY)
213