Removing And Reinstalling The Front Bezel; Installing Or Replacing A Pci Card - Lenovo ThinkStation P310 User Manual

Removing and reinstalling the front bezel

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To remove and reinstall the front bezel, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 58.
3. Release the three plastic tabs on the left side and pivot the front bezel outward to remove it from the
computer.
Figure 11. Removing the front bezel
4. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis. Then pivot the front bezel inwards until it snaps into position
on the left side.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 105.

Installing or replacing a PCI card

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Your computer has two PCI Express x1 card slots, one PCI Express x16 card slot (negotiable link width x4,
x1), and one PCI Express x16 graphics card slot (graphics card available on some models).
To install or replace a PCI card, do the following:
.
Chapter 7 Installing or replacing hardware
59