Installing And Removing The Memory Modules - Supermicro Supero X9DRi-LN4F+ User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's Website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
LE2
SW1
UID
LEM1
JP7
JP6
JI2C2
JI2C1
XDP-CPU
JWP1
J18
JF2
SAS4~7 SAS0~3
J17
JD1
1 1
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.
Removing Memory Modules
Press both notches at the ends of a DIMM module to unlock it. Once it is loosened,
remove the DIMM module from the motherboard.
modules to prevent any possible damage.
LAN2/4 LAN1/3 USB 2/3 USB 0/1
VGA COM1
IPMI_LAN
CPU2
X9DR3-LN4F+/X9DRi-LN4F+
Rev. 1.10
CPU1
LE1
JF1
FAN1
CAUTION
2-11
Chapter 2: Installation
Notches
Release Tabs