Listening To The Radio; Direct Access Tuning Using The Remote; Using The Remote Controller (Rc-405); Changing The Frequency Steps - Kenwood KDC-U553BT Instruction Manual

Listening to the Radio

SRC to select "TUNER".
Press
1
Press repeatedly to select a band (FM1/
2
FM2/ FM3/ AM).
Press 4 / ¢ to search for a station.
3
The tuning mode can be changed. Refer to
■ ■
<SEEK MODE> (page 8).
Direct Access Tuning using the
remote controller (RC-405)
Press FM+ / AM– to select a band.
1
Press DIRECT to enter Direct Access
2
Tuning mode.
"– – – –" appears.
Press the number buttons to enter the
3
frequency.
Press 4 / +¢ to search for the
4
frequency.
To cancel Direct Access Tuning mode, press
■ ■
or EXIT.
If no operations is done for 10 seconds after
■ ■
step 3, Direct Access Tuning is automatically
canceled.

Using the remote controller (RC-405)

#FM+ / *AM– : Selects band.
4 / +¢
: Selects station.
1 – 6
: Selects preset station.
Item
SEEK MODE AUTO1 *: Automatically search for a station. ; AUTO2: Search in the order of the stations in the preset memory. ;
MANUAL: Manually search for a station.
AUTO MEMORY YES: Automatically starts memorizing 6 stations with good reception. ; NO *: Cancels (automatic memorizing is
not activated). (Selectable only if [NORMAL] is selected for [PRESET TYPE].) (page 5)
MONO SET ON: Improves the FM reception (but the stereo effect may be lost). ; OFF *: Cancels (stereo effect resumes).
8
English
PAR
VOICE
Press and hold to memorize the current station.
■ ■
Press briefly to recall memorized station.
■ ■

Changing the frequency steps

You can change the frequency step of FM/
AM.
FM : 50 kHz to 200 kHz
AM : 9 kHz to 10 kHz
Press and hold
1
power.
While pressing number buttons 1 and 5,
2
press
Release your fingers from the buttons after
the display appears.
To restore the initial setting, repeat the same
■ ■
procedure.
When the frequency step is changed, the
■ ■
frequencies in the memory are deleted.

Adjust [SETTINGS] mode settings

While listening to the radio...
Press the volume knob to enter
1
[FUNCTION] mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to make a
3
selection, then press to confirm.
See table below for selection.
Hold
4
Selectable setting (Preset: *)
iPod
SRC to turn off the
SRC.
to finish the procedure.