Bluetooth Setup; Selecting The Bluetooth Device; Bluetooth Device Registration Test - Kenwood KDC-U553BT Instruction Manual

Cd-receiver
Table of Contents

Advertisement

Bluetooth Setup

Selecting the Bluetooth Device

Press
to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [PHONE
4
SELECT] or [AUDIO SELECT], then press
to enter.
Turn the volume knob to select a
5
Bluetooth device name.
Press the volume knob to set up the
6
Bluetooth device.
"✱ (device name)": The selected
■ ■
Bluetooth device is busy.
"- (device name)": The selected Bluetooth
■ ■
device is on standby.
"(blank) (device name)": The Bluetooth
■ ■
device is deselected.
If two cell-phones or an audio player
■ ■
have already been selected, deselect one
device before selecting a new Bluetooth
device.
Hold
to finish the procedure.
7
To cancel the Bluetooth mode, press
■ ■

Bluetooth Device Registration Test

You can check whether your Bluetooth device
can be registered using this unit.
Press and hold
1
"PAIRING" is displayed.
"PLEASE PAIR YOUR PHONE" is displayed.
2
When "(device name)" is displayed, select
■ ■
"[PAIRING]" and press the control knob.
When "DEVICE FULL" is displayed, delete a
■ ■
Bluetooth device and retry.
1. Turn the volume knob to select the
Bluetooth device, then press and hold
to confirm.
2. Turn the volume knob to select "YES",
then press to confirm.
20
English
to enter pairing mode
Start registering this unit by operating
3
the Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit or audio unit (pairing).
Select "KENWOOD BT CD/R-5T1" from the
list of found units.
Input the PIN code ("0000") in the
4
Bluetooth device.
Check that registration is complete on
the Bluetooth device. PIN code is set to
"0000" as the default. You can change this
code. Refer to [PIN CODE EDIT] under
<Bluetooth Setup> (page 21).
"(device name)" is displayed. Press and
5
hold the volume knob.
"BT TEST" is displayed.
The connection result, "OK" or "NG", is
6
displayed.
"PAIRING": Registration to this unit
■ ■
"HF CNT": Hands-free phoning
■ ■
"AUD CNT": Audio playback
■ ■
"PB DL": Phone Book downloading
■ ■
Press
7
Data (Phone Book, etc.) of the cell-phone
■ ■
checked for connection does not remain in
.
this unit.
Bluetooth Setup
Press
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to make a
3
selection, then press to confirm.
See table below for selection.
■ ■
Repeat step 3 until the desired item is
■ ■
selected/activated.
Press
■ ■
Hold
4
To cancel the Bluetooth mode, press
■ ■
to exit pairing mode.
to enter Bluetooth mode.
to return to the previous item.
to finish the procedure.
.

Advertisement

Table of Contents
loading

Table of Contents