Srx3400 Services Gateway Srx Clustering Module; Figure 15: Routing Engine; Figure 16: Srx Clustering Module - Juniper SRX3400 Hardware Manual

SRX3400 Services Gateway Hardware
Related
Documentation

SRX3400 Services Gateway SRX Clustering Module

36
The services gateway must have one Routing Engine installed in slot RE0. A Gigabit
Ethernet port on the front panel of the Switch Fabric Board (SFB) is connected directly
to the processors on the REs for management purposes. The SFB port labeled
connects to the Routing Engine in slot RE0.
ETHERNET 0
NOTE: Unless you have installed an SRX Clustering Module (SCM) in slot
RE1, the empty RE1 slot should have a blank panel installed to shield it and
to allow cooling air to circulate properly through the services gateway.

Figure 15: Routing Engine

For detailed information about the Routing Engines supported by the services gateway,
see the SRX1400, SRX3400, and SRX3600 Services Gateway Module Guide at
www.juniper.net/techpubs/
SRX3400 Services Gateway Chassis on page 23
Available Components for the SRX3400 Services Gateway on page 19
Hardware Component Locations in the SRX3400 Services Gateway Chassis on page 21
The SRX Clustering Module (SCM) is a card that you can install in the services gateway
to enable the dual control link feature for chassis cluster supported in Junos OS Release
10.2 and later. You install the SCM in the
The SCM is shown in Figure 16 on page

Figure 16: SRX Clustering Module

NOTE: The services gateway must be running Junos OS Release 10.2 or later
to use the SCM. When running earlier Junos OS Releases, the services gateway
does not properly recognize it.
.
RE1 slot on the rear panel of the services gateway.
36.
RE
Copyright © 2013, Juniper Networks, Inc.