Srx3400 Services Gateway Srx Clustering Module; Figure 8: Srx Clustering Module - Juniper SRX3400 Hardware Manual

Related
Documentation

SRX3400 Services Gateway SRX Clustering Module

Copyright © 2017, Juniper Networks, Inc.
The services gateway must have one Routing Engine installed in slot RE0. A Gigabit
Ethernet port on the front panel of the Switch Fabric Board (SFB) is connected directly
to the processors on the REs for management purposes. The SFB port labeled
connects to the Routing Engine in slot RE0.
ETHERNET 0
NOTE: Unless you have installed an SRX Clustering Module (SCM) in slot
RE1, the empty RE1 slot should have a blank panel installed to shield it and
to allow cooling air to circulate properly through the services gateway.
Figure 7: Routing Engine
For detailed information about the Routing Engines supported by the services gateway,
see the
SRX1400, SRX3400, and SRX3600 Services Gateway Module Guide
www.juniper.net/techpubs/
SRX3400 Services Gateway Chassis on page 19
Available Components for the SRX3400 Services Gateway on page 5
Hardware Component Locations in the SRX3400 Services Gateway Chassis on page 20
The SRX Clustering Module (SCM) is a card that you can install in the services gateway
to enable the dual control link feature for chassis cluster supported in Junos OS Release
10.2 and later. You install the SCM in the
The SCM is shown in Figure 8 on page

Figure 8: SRX Clustering Module

Chapter 2: Hardware Component Overview
.
slot on the rear panel of the services gateway.
RE1
17.
RE
at
17