Page 2
Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography.
Handsomely finished in a choice of black anodized or brushed aluminum, Crestron FlipTops lend a contemporary metallic accent to conference tables and podiums. The FT-600 installs cleanly in virtually any flat, horizontal surface up to 1 3/4” (44 mm) thick. Beveled edges provide for a nearly flush appearance.
Page 6
• AC Power Outlet Modules – To provide power for laptops and other portable devices, the FT-600 can be equipped with up to four AC power outlets. A single FTA-PWR-102 Dual AC Power Outlet Module* can be installed in place of the center two connector plates or two FTA-PWR-102s can be installed in place of all four connector plates.
Crestron FT-600 FlipTop Basic Specifications Specifications for the FT-600 are listed in the following table. FT-600 Specifications SPECIFICATION DETAILS Power Requirements Utility power 10 amps at 125 Vac 50/60 Hz per each installed Dual AC Power Outlet Module (FTA-PWR-102, sold separately)
FlipTop Basic Crestron FT-600 Physical Description This section provides information on the connections, controls, and indicators available on the FT-600. FT-600 Overall Dimensions (Top View) 7.98 in (203 mm) 6.22 in (158 mm) 6.77 in (172 mm) 4 • FlipTop Basic: FT-600...
Attach each plate by first sliding its dovetail into the slot toward the rear of the inside of the FT-600, then dropping the front into place and securing it with the 06-32 x 1/4” screw from step 1. Refer to the following illustration.
Page 13
06-32 x 1/4” Screws (2) Mounting in a Surface The FT-600 is designed to mount in a horizontal surface, such as a desktop, lectern, or podium. The following diagram illustrates the required opening size to accommodate the FT-600. A cutout template (40143) is included.
Page 14
FlipTop Basic Crestron FT-600 Use the following procedure to mount the FT-600. Position the FT-600 in the mounting hole. Mounting Plate Stud Locations Studs for Mounting Plate Surface Cutout Install the four #10-32 socket screws (2037109) in the metal mounting plates (2036985) (two screws per plate).
Page 15
Mounting Plates (2) Screws (4) #10-32 x 2”, Steel, Socket HD Slide the mounting plates over the studs on each side of the FT-600. Turn the four #10-32 socket screws equally, until they contact the underside of the mounting surface.
Crestron worldwide offices at www.crestron.com/offices. To post a question about Crestron products, log onto Crestron’s Online Help at www.crestron.com/onlinehelp. First-time users must establish a user account to fully benefit from all available features.
(property or economic damages inclusive) arising from the sale or use of this equipment. Crestron is not liable for any claim made by a third party or made by the purchaser for a third party.
Page 18
FlipTop Basic Crestron FT-600 This page is intentionally left blank. 14 • FlipTop Basic: FT-600 Operations & Installation Guide – DOC. 7596A...
Page 19
Crestron FT-600 FlipTop Basic This page is intentionally left blank. Operations & Installation Guide – DOC. 7596A FlipTop Basic: FT-600 • 15...