[Status] - Panasonic PT-DZ870U Operating Instructions Manual

4) Press qw to switch the item.
[9600]
[19200]
[38400]
5) Press as to select [(OUT) PARITY].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Setting the response
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [RESPONSE(ID ALL)].
4) Press qw to switch the item.
[ON]
[OFF]
5) Press as to select [GROUP].
6) Press qw to switch the item.
[A] - [Z]
7) Press as to select [RESPONSE(ID GROUP)].
8) Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL INTERFACE BOX], communication using that serial terminal is available only when the
corresponding device (such as the optional Digital Interface Box (Model No.: ET-YFB100G)) is connected to the <DIGITAL LINK/LAN>
terminal.
f When transferring logos via the optional Digital Interface Box (Model No.: ET-YFB100G), "NO SIGNAL SLEEP" of ET-YFB100G must be set
to "OFF" to avoid cutting off communication.
f When [INPUT SELECT] is set to [DIGITAL INTERFACE BOX], communication speed is fixed to 9 600 bps.

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[INPUT]
[SIGNAL NAME]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select the proper speed.
Select the parity condition.
Returns the response when the ID setting is ALL.
Does not return the response when the ID setting is ALL.
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
Returns the response when the ID setting is GROUP.
Does not return the response when the ID setting is GROUP.
Displays the input terminal currently selected.
Displays the input signal name.
ENGLISH - 119