Error Information Page - Panasonic PT-DZ870U Operating Instructions Manual

Error information page

When [Error (Detail)] or [Warning (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to display the
error/warning details.
f The projector may go into the standby status to protect the projector depending on the contents of the error.
1 Self-diagnosis result display
Displays the item check results.
[OK]:
Indicates that operation is normal.
[FAILED]:
Indicates that there is a problem.
[WARNING]:
Indicates that there is a warning.
r [FAILED] items
Parameter
[MAIN CPU BUS]
[FAN]
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[AROUND LAMP TEMPERATURE]
[LAMP1 REMAIN TIME]
[LAMP2 REMAIN TIME]
[LAMP1 STATUS]
[LAMP2 STATUS]
[APERTURE(CONTRAST-SHUTTER)]
[SHUTTER(MUTE-SHUTTER)]
[INTAKE AIR TEMP.SENSOR]
[OPTICS MODULE TEMP.SENSOR]
[AROUND LAMP TEMP.SENSOR]
[BATTERY]
[COLOR WHEEL]
[LENS MOUNTER]
[COVER OPEN]
[BRIGHTNESS SENSOR]
[ANGLE SENSOR]
[AIR FILTER CASE]
Chapter 4 Settings — [NETWORK] menu
There is a problem with the microcomputer circuitry. Consult your dealer.
There is a problem with the fan or the fan drive circuit. Consult your dealer.
The air intake temperature is too high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance.
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
The temperature around the lamp is high. The air exhaust port may be blocked.
The runtime of the lamp has exceeded the specified time, and it is time to replace the
lamp.
The lamp has failed to turn on. Wait a while until the luminous lamp cools off, and then
turn on the power.
There is a problem in the contrast shutter circuit for dynamic iris. Consult your dealer.
There is a problem with the shutter circuitry. Consult your dealer.
There is a problem with the sensor used to detect intake temperature. Consult your
dealer.
There is a problem with the sensor used to detect temperature inside the projector.
Consult your dealer.
There is a problem with the sensor used to detect exhaust air temperature. Consult your
dealer.
Battery replacement is required. Consult your dealer.
There is a problem with the color wheel or the color wheel drive circuit. Consult your
dealer.
There is a problem in the lens mounter. Consult your dealer.
Installation of the lamp unit cover is incomplete. Check the installation of the lamp unit
cover. (x page 162)
There is a problem with the luminance sensor. If problems persist even after switching
on the power, consult your dealer.
There is a problem with the sensor that detects angle. Consult your dealer.
The air filter case is not attached. Check the attachment of the air filter unit.
(x page 160)
1
Description
ENGLISH - 141