17.10.1.3 Page Descriptor
Table 74: Mode Parameter Page Format
Byte 0
PS
Byte 1
Byte 2-n
Each mode page contains a page code, a page length, and a set of mode parameters.
When using the MODE SENSE command, a Parameter Savable (PS) bit of one indicates that the mode page can be saved by
the drive in the reserved area of the drive. A PS bit of zero indicates that the supported parameters cannot be saved. When
using the MODE SELECT command, the PS bit is reserved (zero).
SPF (Sub-Page Format) is set to zero to indicate the short page format is used. The drive supports the following mode page
codes:
Table 75: Supported Page Codes
Page
00
Vendor Unique Parameters
01
Read-Write Error Recovery Parameters
02
Disconnect/Reconnect Control Parameters
03
Format Device Parameters
04
Rigid Disk Geometry Parameters
07
Verify Error Recovery Parameters
08
Caching Parameters
0A
Control Mode Page
0C
Notch Parameters
19
Port Control Page
1A
Power Control Parameters
1C
Informational Exceptions Control
The page length field specifies the length in bytes of the mode parameters that follow. If the Initiator does not set this value to
the value that is returned for the page by the MODE SENSE command, the drive will terminate the command with Check Con-
dition status.
SPF
Page Length
Mode Parameters
Description
Hitachi Ultrastar 15K147 SCSI Hard Disk Drive Specification
Page Code
110
PS
1
1
1
0
0
1
1
1
1
1
1
1