Reserve (16) - Hitachi HUS151473VL3800 - Ultrastar 73.4 GB Hard Drive Specifications

17.29 RESERVE (16)

Table 141: RESERVE (16)
Byte
7
0
1 Reserved = 0
2
(MSB)
3-4
5 VU = 0
The RESERVE command is used to reserve a LUN for an Initiator. This reservation can be either for the Initiator that sends
this command or for the third party that is specified in this command.
This command results in reserving the entire LUN for the Initiator until one of the following occurs:
- The reservation is superseded by another valid RESERVE command from the Initiator that made the reservation.
- The LUN is released by a RELEASE command from the same Initiator.
- A hard reset condition occurs (a SCSI bus Reset assertion).
- A TARGET RESET message is received from any Initiator.
- Power off/on occurs.
• 3rdPty bit is to indicates that
1 this reservation is for a third party that is specified by 3rd Party ID.
0 this reservation is for the Initiator itself.
• 3rd Party ID specifies the ID of the third party for which the LUN is reserved.
Note: The LUN may be only released by the Initiator who sent the RESERVE command.
• Extents must be 0. Extension is not supported by the drive.
• Reservation Identification is ignored.
• Extent List length must be zero. Extent List length is not supported.
Hitachi Confidential
6 5 4
Command Code = 16h
3rdPty
Reservation Identification
Extent List Length = 0
Reserved = 0
Hitachi Ultrastar 15K147 SCSI Hard Disk Drive Specification
Bit
3 2
3rd Party ID
181
1 0
Ext=0
(LSB)
FLAG LINK