Table 6-51 Power Condition Control Page - Hitachi DK32EJ - Ultrastar Series 36.9 GB Hard Drive Reference Manual

[ Mode Page 1A
Table 6-51 Power Condition Control Page (Page Code = 1A
Bit
Byte
0
1
2
3
4 (MSB)
|
7
8 (MSB)
|
11
An Idle bit of one indicates that the logical unit shall use the idle condition timer
field to determine the length of inactivity time to wait before entering the idle
condition. An Idle bit of zero indicates that the logical unit shall not enter the idle
condition.
Since the controller does not support Idle bit, this bit ignore.
A Standby bit of one indicates that the logical unit shall use the standby condition
timer field to determine the length of inactivity time to wait before entering the
standby condition. A standby bit of zero indicates that the logical unit shall not
enter the standby condition.
Since the controller does not support Standby bit, this bit ignore.
The idle condition timer field indicates the inactivity time in 100 millisecond
increments that the logical unit shall wait before entering the idle condition.
Since the controller does not support idle condition timer field, this field ignore.
If the idle bit is one, a value of zero in the idle condition timer indicates the logical
unit shall enter the idle condition on completion of any command.
MODE SELECT:(15h)
6 COMMAND DESCRIPTIONS
]
H
7 6 5
Reserved
0 0 0
0 0 0
0 0 0
Reserved
0 0 0
Standby Condition Timer
4 3
Page Code(1A
1 1
Page Length
0 1
Reserved
0 0
0 0
Idle Condition Timer
OEM MANUAL:K6602771
)
H
2 1 0
)
H
0 1 0
0 1 0
0 0 0
Idle Standby
0
(LSB)
(LSB)
Revision: 2 / Date: 2002.12.19
Page: 192 / 313