Microsoft Windows 2000 users
Under Windows 2000, you may see the screens below.
If you do not see these screens, then the installation has
completed automatically.
Enter the location of the Delphi Mobile Navigation USB
driver disk D:\USBDRIVER.
Note: The "D" drive may not be your CD-ROM drive. Use the letter
designating your CD-ROM drive.
Select "OK." You may now continue to step 2.
Microsoft Windows ME and 98SE users
Under Windows ME and 98SE, you may see the screens
below. If you do not see these screens, then the installa-
tion has completed automatically.
8
Enter the location of the Delphi Mobile Navigation USB
driver disk D:\USBDRIVER.
Note: The "D" drive may not be your CD-ROM drive. Use the letter
designating your CD-ROM drive.
Select "OK." You may now continue to step 2.
Step 2: Installing SmartST application
Note: SmartST has been preinstalled on your unit. This step is necessary
only if you need to reinstall it for any reason. Otherwise continue to
step 3.
This function allows you to install SmartST software onto
a Delphi Mobile Navigation unit. Before beginning, make
sure the unit is connected to the computer via the USB
port. Refer to step 1 on page 6 for more information.
(Your unit is correctly connected if the display shows a
computer and Delphi Mobile Navigation connected.)
1. Select "Install Application" from the main menu.
You will lose all of your settings, favorites, and shortcuts when
you upgrade your software. Use the backup function to save
these settings before upgrading the software. Refer to "Backup"
on page 10 for more information.
You will need Microsoft Internet Explorer version 5.5 or
above to correctly activate the software.
Note: The product key codes are located on the back of the SmartST CD
sleeve. These codes are required every time you install and register the
SmartST software and Map Data. Keep them in a safe place.
Need help?
Do you have a question about the NA10000-11B1 - Mobile Navigation - GPS Receiver and is the answer not in the manual?