Delphi NA10000-11B1 - Mobile Navigation - GPS Receiver User Manual page 15

10. Snap Delphi Mobile Navigation onto the socket clip.
First, position the two locating tabs (found on the
bottom of the unit) into the corresponding slots on
the socket clip. Then, snap the top side of Delphi
Mobile Navigation onto the clip.
To unclip Delphi Mobile Navigation from the mounting bracket,
press down on the back of the upper plastic clip. Release the top
of the unit. Then lift the unit out of the bottom two slots.
11. Flip the GPS antenna outward so that the antenna
points horizontally.
Antenna
points up
and out
12. Plug the 12/24V power adaptor into the cigarette
lighter socket.
13. Plug the other end of the power cable into the socket
on the left side of Delphi Mobile Navigation.
14. Verify that Delphi Mobile Navigation is positioned such
that the GPS antenna has a clear view of the sky.
Note: In most vehicles, you will need to have the engine idling in order
to program your destination. You also can turn on the unit with just the
accessory power (i.e., your ignition key turned to the ACC "on" position).
When you turn on the engine, power may be interrupted to the unit but
the programmed destination will be saved. In vehicles where accessory
power is on permanently, the unit can be turned on and programmed as
soon as the power adaptor is connected. Turning the engine on will not
reset the unit.
15