Assembly - Dimplex Optimyst DFI400LH Owner's Manual

Assembly

1. Carefully unpack all of the
components from the box.
(Figure 5)
2. Remove top cover by turning
the retaining tabs on both ends
of the water reservoir. (Figure
6)
3. Install the light bulbs by
Figure 5
Log Media
Rock
Media
Removable Refill
Container
Light Bulbs
Housing
Media
Tray
Transducer
Remote
Control
aligning the pins on the bulbs
and the fixture and pressing
down until they are fully
inserted. (Figure 7)
4. Install the transducer so that
it is sitting level in the circular
holding area in the reservoir.
5. Orient transducer wire so that
it does not sit directly above
the emitter and the wire passes
through the slot in the side of
the tank. (Figure 6)
6. Reinstall the top cover and
ensure both retaining tabs have
been turned so that they are
pointing inwards.
7. Fill and install the Refill
Container.
!
NOTE: Normal tap water can
be used in the Optimyst
as the tap water is not considered
to be hard water. In the event your
tap water is hard, you may use soft-
ened water or distilled water with
1/8 tsp of salt (0.5 mL) added to the
water reservoir. (The addition of
additional salt should only be used
when you notice that the unit is not
producing mist as expected.)
!
NOTE: During initial installation,
the Refill Container should be
refilled after the Reservoir has filled
to ensure the maximum operating
time.
as long
®
9