Netvanta 3458 Rear Panel Design; Figure 15. Netvanta 3458 Rear Panel Layout - ADTRAN NetVanta 3200 series Hardware Installation Manual

NetVanta 3200/3300/3400 Series

NetVanta 3458 Rear Panel Design

The NetVanta 3458 rear panel is shown below with a module installed. Appendix A on page 85 provides
pinouts.
SLOT 1 NET/DBU
NetVanta 3458 Rear Panel Interfaces
SLOT 1/SLOT 2 NET/DBU Option Slots
The
SLOT 1/SLOT 2 NET/DBU
option modules are described in the section
PoE
The NetVanta 3458 has a 48 VDC port on the rear panel to provide the voltage required for PoE
applications. This port is active only if the NetVanta 3458 has been ordered with the PoE option. Note
that the NetVanta 3458 itself cannot be powered by this port.
8 Switch Port Interfaces
Ports 1 through 8 are RJ-45 connectors used to access the fully managed 10/100Base-T Ethernet
switch.
10/100Base-T Ethernet Interfaces
The Ethernet ports (
• 10Base-T or 100Base-T dual stacked connector
• Auto-MDIX
• Auto-negotiation
• CSMA/CD
• IEEE 802.3 compatibility
Power Connection
All of the 1U-high products have universal power supplies and are shipped with the appropriate cable.
Please refer to Supplying Power to the Unit on page 69
61200860L1-34AB
SLOT 2 NET/DBU

Figure 15. NetVanta 3458 Rear Panel Layout

option slots support various NIM plug-in option modules. These
ETH 0/1 and ETH 0/2 ) are RJ-45 connectors. These ports provide the following:
Copyright © 2012 ADTRAN, Inc.
PoE
48V
Option Modules on page
for connection details.
Physical Descriptions
SWITCH
ETH 0/1
1 2 3 4
5 6 7 8
ETH 0/2
41.
39