American Dryer Corp. Phase 6 Microprocessor Controls ML-190HS Service Manual

Phase 6 microprocessor controls

Download this manual

ML-190HS

Service Manual

Phase 6

Microprocessor Controls

Page 1 ML-190HS Service Manual Phase 6 Microprocessor Controls...
Page 2 DATE OF PURCHASE DISTRIBUTORS NAME Serial Number(s) Replacement parts can be obtained from your distributor or the ADC factory. When ordering replacement parts from the factory, you can FAX your order to ADC at (508) 678-9447 or telephone your orders directly to the ADC Parts Department at (508) 678-9000.
Page 3: For Your Safety
YOU MUST DISCONNECT and LOCKOUT THE ELECTRIC SUPPLY and THE GAS SUPPLY or THE STEAM SUPPLY BEFORE ANY COVERS or GUARDS ARE REMOVED FROM THE MACHINE TO ALLOW ACCESS FOR CLEANING, ADJUSTING, INSTALLATION, or TESTING OF ANY EQUIPMENT per OSHA (Occupational Safety and Health Administration) STANDARDS.
Page 4 DRYER MUST NEVER BE OPERATED WITHOUT THE LINT FILTER OR SCREEN IN PLACE, EVEN IF AN EXTERNAL LINT COLLECTION SYSTEM IS USED. PLEASE OBSERVE ALL SAFETY PRECAUTIONS displayed on the equipment and specified in the installation and operator's manual included with the dryer.
Page 5 Table of Contents...
Page 14 SECTION IV...
Page 22 To Remove HSI (Hot Surface Ignition) Ignitor...
Page 52 ALL REV ANTI WRINKL dELAY TIME ANTI WRINKL GUARd ACTIVE ANTI WRINKL GUARd ON TIME AUTO CYCLE bURNER CONTROL FAIL bURNER FLAME FAIL bURNER SAFETY FAIL bUZZ bUZZ TIME ºCEL CHECK MAIN FUSE CLEAN LINT COOL COOL TIME__M COOL TEMP___ CYCLEA CYCLEb CYCLEC...
Page 58 ºF = (ºC + 32) EMPERATURE ºC = (ºF - 32) ºC + ºK (273.15) ENSOR URRENT 1,000,000 (µ A) MICROAMPS...