Reprogramming A Single Button; Programing The Transmitters - Ford Super Duty Owner's Manual

Hide thumbs Also See for Super Duty:

Table of Contents

176 Universal Garage Door Opener (If Equipped)

Erasing the Function Button Codes

Reprogramming a single button

To program a device to a previously trained button, follow these steps:

1. Press and hold the desired button. Do NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink® at www.homelink.com

or 1-800-355-3515.

Programming HomeLink® to a Genie Intellicode® 2 garage door

Note: The Genie Intellicode® 2 transmitter must already be

programmed to operate with the garage door opener.

To program HomeLink® to the transmitter you must first put the

transmitter into programming mode. To do this:

2013 F-250/350/450/550 (f23)

Owners Guide gf, 2nd Printing, December 2012

Note: You cannot erase individual

1. Press and hold the outer two function

buttons simultaneously for approximately

20 seconds until the indicator lights above

the buttons flash rapidly.

2. When the indicator lights flash, release

the buttons. The codes for all buttons are

B. Green LED

Show Quick Links

Table of Contents